Meraki POE-INJ-3

802.3af Power over Ethernet Injector, 10/100/1000Mbps

802.3af PoE Injector

The Meraki PoE Injector allows delivery of both data and power to a Meraki access point over a single Ethernet cable, allowing deployment of devices exactly where they are needed to provide the best wireless coverage and at much lower installation cost. This PoE injector is specifically designed to meet the power needs of Meraki 802.3af-compatible devices. Check the access point specifications to ensure compatibility.

Easy Installation

Use Power Over Ethernet to supply power (and optionally data) to Meraki 802.3af compatible devices. Ethernet cable is inexpensive and easy to install. Simply plug the AC adapter into the side of the Meraki PoE injector, then plug ethernet cable into the PoE port and route that cable to your 802.3af-compatible device. To add a wired data connection, plug the data ethernet cable into the LAN port on the Meraki PoE Injector.

Power

Input Voltage: 100 to 240 VAC

Input Current: 0.5A max. for 90 VAC, 0.35A max. for 240 VAC

AC Input Frequency: 47-63 Hz

Maximum Output Power: 19.6 W

Powered device can be up to 100m away from power injector

Data

Compatible with 10/100/1000 Mbit/s Ethernet, full duplex

Environmental

Operating Temperature: (32 to 104°F (0 to 40°C)

Storage Temperature: (-16 to 149°F (-30 to 65°C)

Operating Humidity: 5 to 90%

Additional Features

Over-voltage and over-current protection

Short-circuit protection

Physical Dimensions

5.98” x 2.56” x 1.42” (152 mm x 65 mm x 36 mm)

Weight: 1.0 lb (450 g)

Mounting

Mounts to walls (anchors and screws not included)

Compatibility

Complies with 802.3af standard

MR-Series Access Points

LED Indicators

Input Power

Fault

Detect/connected to valid 802.3af load